Picture call out!! Stinger header

[mthd]

Hey all, looking to get my stinger header installed real soon and need some pictures if I could!
Mustang, with front mount, NON holset, I will be running t3/t4 watercooled. also stock upper intake not rotated.

Wondering how much I will need to modify the existing stinger fmic piping or what else I am going to need to do.

Will be making the recirc tube for the WG removable (flanged) with flex (necessary?) and run a dump tube for track use.

Also I should get wrap for the downpipe correct? I don't have hard heater lines just silicone hose.

Thanks all, any suggestions and pictures are much appreciated.

existing setup if it matters
i35.photobucket.com/albums/d198/mthd_1990/IMG_00001098.jpg
i35.photobucket.com/albums/d198/mthd_1990/IMG_00001099.jpg
i35.photobucket.com/albums/d198/mthd_1990/IMG_00001100.jpg

[Stinger]

You'll need to rotate the compressor housing so it the outlet is pointed the same direction as the pics of the header style FMIC kit on the site. Then you'll need to add 3" to the tubing at the throttle body and at the other end of that pipe (driver's side below the battery).

Flex is necessary, as mentioned in the header listing on the site. Running a dump tube at the track is pointless. You'll gain no power but you will lose the ability to hear detonation.

Don't wrap the downpipe unless you want it to rust out because it holds condensation when it's not being driven.

[scooter1112]

I wrapped my stinger center mount. Bad idea?

[Stinger]

Yes