CAS wiring

[cmartin]

I am about to order a stinger CAS setup. I am a bit confused on the wiring. This is the first ms3x I have built. I have in the past built and used several MS2 units and just gone with the basic TFI. This time around I wanted to try MS3x and be sequential with COP. I have read the documentation on the CAS and it recommends with "full sized" megasquirts to use the VR circuit. So my question is, when wiring the sensor am I using the VR input on the main connector, which would be pin24? Or do I use the expansion harness VR cam circuit pin 32? I plan to run sequential using LS coils. Based on what i read the CAS will allow me to do full sequnetial

[wesk]

Primary position input always on main board.

[cmartin]

awesome thank you. So nothing connects to the cam sensor input? How does it get full sequential without both inputs?

[wesk]

One wheel at cam speed with a singularity (missing tooth) completely defines engine position.

[cmartin]

alright thanks for the clarification.