Turbonetics F1-57 Turbine Wheel & Stock Exhaust Elbow

[xr2300]

Has anyone run a Turbonetics AR63 turbine with the F1-57 wheel, and a stock exhaust elbow?  I measured the two and they are both within a millimetre.  It Looks tight LOL .........  Its a shame the outlet on the elbow is just under a 1/4" smaller.


photos.app.goo.gl/tg9N7XjSieH4MgDi8


photos.app.goo.gl/wndk5FoFLkCrssrP9

[Stinger]

It will bolt on fine. As you found, some massaging of the opening of the elbow would be idea so there isn't a flat ledge for exhaust flow to bounce off of on each side.

[xr2300]

Great. I thought about that too. The elbow is thick enough and can be ported. Time to send it to Schlodes. 😀

[Stinger]

Or spend a few minutes on it with a grinder.

[xr2300]

Ya, I don't have those tools unfortunately.