MrGee
Boosting 20 psi
Posts: 86
|
Post by MrGee on May 8, 2023 7:09:04 GMT -5
From the part description page for Pierburg Electronic Boost Solenoid: "Install instructions on the PiMP/PiMPx support forum FAQ thread." I was unable to find the instructions in a sea of information and questions. I just need to know were to wire in. I have the coil on plug harness, CAS, and expansion harness. If instructions came with it, I've misplaced them. Thanks.
|
|
|
Post by Stinger on May 8, 2023 9:46:52 GMT -5
The ECU's startup guide says what wire is used for boost control. The details regarding plumbing, software settings, configuration, etc. are in the PiMPxs FAQ thread that is "pinned" near the top of that forum section so it's always viewable without searching any time you open the PiMPxs section of this forum: stinger-performance.proboards.com/post/46143/thread
|
|