|
Post by Decepticon72 on Aug 20, 2013 14:40:25 GMT -5
I am seventeen this is my first build and I have read a lot on this site and other sites and decided you guys were the most educated on the subject. I have swapped a 85 2.3l svo into a ranger XL that had no Tach unfortunately I over reved the engine spinning a rod bearing. Now it has a Tach... I currently have the engine completely tore down . The Crank is being turned and polished the block is being honed and hot tanked. I am getting a valve job on the head and was wondering if anyone knew a reliable source to buy parts from I am looking for a full gasket set, oil pump, water pump, all the bearings mains and rods, valves and valve seals, total seal piston rings and I am also looking for a dummy block off for the distributor because I am running coil packs right now and in the future looking to megasquirt. If anyone has any good advice I am always up for better suggestions im not trying to spend an arm and a leg though. Thank you for your time.
|
|
|
Post by Decepticon72 on Aug 20, 2013 22:00:07 GMT -5
I found a gasket set bearings valve stem seals and valves and piston rings for $174.
|
|