jinx44
Boosting 5 psi
Posts: 19
|
Post by jinx44 on Jun 11, 2009 10:54:30 GMT -5
I have a couple questions about your bell housing adapter.
#1. How thick is it?
#2. Is there any way I can get a wider plate made so I can use it as a mid plate?
|
|
|
|
Post by Stinger on Jun 13, 2009 12:03:17 GMT -5
It's about 3/8" and yes, it can be special ordered to be used as a midplate for an additional fee.
|
|
jinx44
Boosting 5 psi
Posts: 19
|
Post by jinx44 on Jun 13, 2009 13:07:19 GMT -5
It's about 3/8" and yes, it can be special ordered to be used as a midplate for an additional fee. Awesome. One other question: Will a SBF flexplate bolt to the 2.3? I thought I had one laying around here to try, but I can't find it. Obviously it will have to be zero balance, but I just need to find out what will bolt to the crank. |
|
|
|
Post by Stinger on Jun 13, 2009 13:09:18 GMT -5
Crank pattern is different.
|
|
jinx44
Boosting 5 psi
Posts: 19
|
Post by jinx44 on Jun 13, 2009 13:15:58 GMT -5
Crank pattern is different. Does anyone make a large diameter flexplate for the 2.3 crank that you know of? |
|
|
|
Post by Stinger on Jun 13, 2009 20:24:12 GMT -5
Reactor flywheel will make you anything you desire.
|
|
jinx44
Boosting 5 psi
Posts: 19
|
Post by jinx44 on Jun 14, 2009 8:49:34 GMT -5
Reactor flywheel will make you anything you desire. Thank you. Does it matter what tooth flexplate is used with your adapter? I would think the starter position would change with the diameter. |
|
|
|
Post by Stinger on Jun 14, 2009 18:35:21 GMT -5
158 tooth I believe is what I use for flywheels.
|
|
