|
|
Post by strangesvo on Oct 28, 2021 8:48:57 GMT -5
Geating ready to purchase your oil inlet line and want to make sure I choose the correct inlet fitting. Installing a Garret GTX28, what should I choose? Assuming it's the same as the Garrett T3 but want to make sure.
Thanks
|
|
|
|
Post by Stinger on Oct 28, 2021 9:50:12 GMT -5
Is it ball bearing or journal bearing?
Best bet is for you to verify what thread it uses and we go from there.
|
|
|
|
Post by strangesvo on Oct 30, 2021 9:06:11 GMT -5
So I think I'm just going to purchase the correct fitting straight from Garrett that way I'm good. When I purchase your kit I'll just need to get a -4AN 90° to male that fits your female end of your hose.
|
|
|
|
Post by Stinger on Oct 30, 2021 9:46:44 GMT -5
That's likely a good plan. I don't know what their fitting looks like but if you can get something that 90's out of the turbo to -4 then our line would connect. We don't carry AN 90's, only NPT to AN 90's like the stock stuff and T3/T4's use.
|
|
